蒽醌修饰石墨毡电极预处理头孢合成废水

以钛涂钌电极为阳极、自制蒽醌修饰石墨毡电极为阴极,对头孢合成废水(COD=25 000~30 000 mg/L、ρ(NH3-N)=850~1 300 mg/L、色度为2 300~2 680度)进行了电化学氧化预处理,优化了电解条件,并对电化学体系的动力学和稳定性进行了分析。实验结果表明:蒽醌的存在可改善电化学氧化降解效果;在电解时间50 min、电流密度0.14 A/cm2、Na2SO4浓度0.1 mol/L、极板间距2 cm、初始废水p H 7.0的条件下,废水的COD、色度、NH3-N的去除率分别可达45.3%,66.9%,33.6%;BOD5/COD由处理前的0.27增至0.40,可生化性得到改善;COD、色度、NH3-N的电化学氧化降解过程均近似符合一级动力学方程;且该电化学体系的应用稳定性良好。     

污泥加热预处理对中温厌氧消化的影响

对污泥加热预处理给中温厌氧混合消化和污泥单独消化带来的影响进行了研究.研究结果表明,污泥加热预处理有利于提高混合消化对 COD 的去除率,尤其是 SCOD 的去除率由 77%增长到 93%,但不利于 TS 和 VS 的去除;而对污泥单独消化,预处理则不利于有机物的去除.采用加热预处理后的污泥进样,混合消化和污泥单独消化的甲烷产气量均有所提高.     

Kitchen waste valorization through a mild-temperature pretreatment to enhance biogas production and fermentability: Kinetics study in mesophilic and thermophilic regimen

Biowaste valorization through anaerobic digestion is an attractive option to achieve both climate protection goals and renewable energy production. In this paper, a complete set of batch trials was carried out on kitchen waste to investigate the effects of mild thermal pretreatment, temperature regimen and substrate/inoculum ratio. Thermal pretreatment was effective in the solubilisation of macromolecular fractions, particularly carbohydrates. The ability of the theoretical methodologies in estimating hydrogen and methane yields of complex substrates was evaluated by comparing the experimental results with the theoretical values. Despite the single batch configuration, a significant initial hydrogen production was observed, prior to methane yield. Main pretreatment effect was the gain in hydrogen production; the extent was highly variable according to the other parameters values. High hydrogen yields, up to 113 mL H2/g VSfed, were related to the prompt transformation of soluble sugars. Thermophilic regimen resulted, as expected, in faster digestions (up to 78 mL CH₄/gVS/day) and sorted out pH inhibition. The relatively low methane yields (342–398 mL CH₄/g VS_fed) were the result of the consistent lignocellulosic content and low lipid content. Thermal pretreatment proved to be a promising option for the enhancement of hydrogen production in food waste dark fermentation.     

2-丁烯醛生产废水的臭氧脱毒预处理

CMW（crotonaldehyde manufacturing wastewater,2-丁烯醛生产废水）污染物浓度高、毒性强、直接采用生物法处理难度大.为了降低CMW的生物处理毒性,采用臭氧氧化法对CMW进行脱毒预处理,并通过考察不同臭氧氧化条件对废水COD_Cr、TOC（总有机碳）、UV_{254 nm}去除率及SMA（specific methanogenic activity,比产甲烷活性）抑制率的影响,获得了优化的臭氧氧化条件,进一步分析了废水脱毒机理.结果表明:①优化的臭氧氧化条件为接触反应时间180 min、初始pH 3.0、反应温度35℃、气相臭氧浓度30.3 mg/L,进气流量500 mL/min;并且在该条件下,CMW中COD_Cr、TOC和UV_{254 nm}的去除率分别为19.9%、9.9%和70.6%,主要特征有机污染物[包括2-丁烯醛、（E,E）-2,4-己二烯醛、3-（2-甲基-2-丙烯）-5-戊内酯、1,5-二甲基-1-烯-4-羰基-环氧己烷、山梨酸乙酯等]的去除率在74.4%以上.②厌氧产甲烷毒性试验结果显示,CMW的SMA抑制率由臭氧氧化前的82.0%降至臭氧氧化后的47.2%.③反应动力学研究显示,CMW中COD_Cr、TOC及UV_{254 nm}的去除过程均符合一级反应动力学方程,R2分别为0.82、0.97、0.94.研究显示,臭氧氧化预处理可以较好地去除CMW中的特征有机污染物,降低废水的厌氧生物处理毒性,是一种可行的脱毒预处理方法.      

柴油机尾气中PAH_s的分析

本文概述了柴油机尾气中ＰＡＨｓ的分析方法，着重论述了采样及预处理方法，特别对预处理方法进行了深入的探讨。另外，通过对柴油机两种不同工况下产生的尾气进行分析后发现，柴油机转速越高，其排放尾气中ＰＡＨｓ的含量就越低。     

石墨炉原子吸收光谱法测定轻质油中痕量砷时样品前处理方法的探讨

研究了轻质油中痕量砷的几种样品处理方法。实验表明，石墨炉原子吸收光谱法测定时，用碘-甲苯和H2O2-HNO3相结合处理轻质油样品较为合适，萃取效率可达90％。并对影响萃取测定的其它因素作了初步探讨。     

ABR工艺预处理木薯酒糟废水的工程应用

木薯酒糟废水有机物浓度高、悬浮物含量大、pH呈酸性、可生化性能较差 ,通常直接采用固液分离—厌氧 (UASB)—好氧曝气生化法处理效果并不理想 ,而采用ABR工艺进行厌氧水解酸化预处理木薯酒糟废水迄今为止未见报道。经绵阳市酒厂废水治理工程证明 ,强化ABR预处理工序是保证后续处理措施能否正常运行的关键     

抗生素制药废水的处理

锦州九泰制药废水属于不易生化类废水，废水量1000m^3/d，污水站总投资140万元。本文阐述了该工程的水质、预处理、生化处理工艺、活性污泥的培养与驯化及运行效果与设计特点。     

Comparison of mesophilic and thermophilic anaerobic digestions of thermal hydrolysis pretreated swine manure: Process performance, microbial communities and energy balance

Anaerobic digestion (AD) of swine manure (SM) commonly shows low biogas output and unsatisfactory economic performance. In this study, thermophilic AD (TAD, 50 ± 1 °C) was combined with thermal hydrolysis pretreatment (THP, 170 °C/10 bar), to investigate its potential for maximizing biogas yield, securing successful digestion and microbial diversity, as well as improving energy balance. Four lab-scale continuously stirred tank reactors were operated for 300 days and compared with each other, i.e., reactor 1 (raw SM fed in mesophilic AD: RSM-MAD), reactor 2 (THP-treated SM fed in MAD: TSM-MAD), reactor 3 (RSM-TAD), and reactor 4 (TSM-TAD). The results showed that THP was efficient to increase methane production of SM, TSM-TAD mode led to the highest methane yield (129.8 ± 40.5 mL-CH₄/g-VS/day) among the tests (p < 0.05). Although TAD was more likely to induce free ammonia (> 700 mg/L) or volatile fatty acids (> 6000 mg/L) accumulation compared with MAD in start-up phase, TSM-TAD treatment mode behaved a sustainable digestion process in a long-term operation. For TSM-TAD scenario, higher Shannon–Weaver (3.873) and lower Simpson index (0.061) indicated this mode ensured and enlarged the diversity of bacteria communities. Phylum Bathyarchaeota was dominant (59.3%−90.0%) in archaea community, followed by Euryarchaeota in the four reactors. RSM-MAD treatment mode achieved the highest energy output (4.65 GJ/day), TSM-TAD was less effective (−17.38 GJ/day) due to increased energy demands. Thus improving the energetic efficiency of THP units is recommended for the development of TSM-TAD treatment mode.     

城市污水处理厂预热处理混合污泥的高温厌氧消化特性研究

针对165℃、30min预处理后的混合污泥,进行高温厌氧消化的连续试验.研究了在不同的水力停留时间(HRT)下的产气量、有机物的分解率等指标,探讨了"热处理 高温消化"实用化的可行性.结果表明,总固体(TS)为70g·L-1、预热处理后的混合污泥经高温厌氧消化,在HRT.为10、20、30d的条件下,产气率为2.82、1.70和1.19 L·L-1·d-1;降解单位COD的产气量为968、1053和1091 L·kg-1;COD分解率为47%～52%;有机物分解率与HRT的关系符合一级反应动力学关系.COD物质平衡计算结果表明,基质中50%的固态有机物被分解转化,生物气中的甲烷含量可达59.1%.本研究中的厌氧消化反应可归纳为C8.38H19.7O7.59N 3.86H2O→4.38CH4 2.99CO2 NH4 HCO3-.